G310GS OEM (7/8") BAR RISER SPACERS

G310GS OEM (7/8") BAR RISER SPACERSCNC machined Stainless Steel spacers to raise the bars either +10mm or +20mm over standard. Supplied as a set of four, in 10mm steps. New M10 x 90mm countersunk screws provided, with Nyloc nuts and washers. NOTE: ONLY DESIGNED TO FIT WITH THE OEM BAR RISERS AND STANDARD 7 8" HANDLEBARS. NOTE: DISCARD OEM SCREWS AND NUTS, BUT RE USE OEM THICK WASHERS, TOP AND BOTTOM.

although the earlier 250L models do require an extra fork preload bush (supplied in our kit)

CNC machined from stainless steel for durability

- Flame polished edge

billet aluminum SUB mount and frame bracket

Specifically designed lip to fit the SKF Dual Compound Fork Seal kits

Combined Damping Adjuster: 10 clicks out (from fully clockwise)

it is often reported that spacing the screen slightly forward can offer a reduction in turbulence and wind noise (although this tends to be dependent on the riders size/height and helmet of course)

The lower Tank mounting bracket also retains the use of the passenger footrest on that side as required

which can get scored easily by debris and then rust

we would recommend you consider matching it with our dedicated LEVEL 2 fork kit for properly balanced ride-height and geometry - offering a high performance suspension set-up front and rear

and CRF250 Rally - NOT CRF250L

for easy access to trail tools and other essentials