Bulkhead Grip Tool

Bulkhead Grip ToolThis hand grip is used for tightening the nut on a bulkhead in hard to reach places. The textured and knurled surface gives you a good grip and allows you to snug up the nut with your hand, without having to get a wrench in to close spaces. Unfortunately there is no standard nut sizes on bulkheads. Use a caliper to measure the nut, flat to flat, then add 1mm for clearance. 3 4" bulkhead = 42mm 1" bulkhead = 53mm 1. 5" bulkhead = 71mm 2" bulkhead =

* Note: Cups are not designed for holding water for hours

After stamping

(See our Nori feeder for dried sheet foods

A soft mallet can be used if the soap is too hard

We offer multiple sets- each set comes with six discs

Magnets are strong enough for up to 5/8" thick tanks or overflow boxes

https://youtu

so it fits inside the mold

custom colors available at no extra charge(1-2 days extra before shipping

With the magnetic frag rack

Use the magnet to slide it down the glass to the appropriate position

colors as shown